Siemens SINUMERIK FM-NC Installation And Startup Manual page 253

03.96
Note
S
S
Transmission error
If data transmission is aborted with an error message, check the following:
S
S
S
S
Table 11-1
S
S
S
S
S
S
S
S
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
When you are loading drive data, deselect the tape format as well as all
special functions on the right-hand side of the screen for interface settings.
Do not actuate the "Back up boot file" softkey in the drive data menu until
you have reset the control once after loading the drive archive data.
Check/correct the interface settings after display of a message regarding
memory reconfiguration.
Is the password at the correct protection level?
Are the interface parameters (V24 PG/PC) correct?
Has MD 32700, ENC_COMP_ENABLE been set to 0 before importing LEC
data?
Is MD11220 INI_FILE_MODE set to 1 or 2 (see Section 11.4.3)?
Data in _N_INITIAL_INI file
File _N_INITIAL_INI
Option data
Machine data
Setting data
Tool offsets
Zero offsets
Global user data
Local user data
R parameters
11.2 Data backup via MMC 100
Data not contained in file _N_INITIAL_INI
S
Drive machine data
S
Compensation data
– Leadscrew error
compensation
– Quadrant error compensation
– Sag compensation
S
Display machine data
S
Workpieces
S
Global part programs
S
Global subroutines
S
User cycles
S
Standard cycles
S
Definitions and macros
11 Data Backup
11-253
11