Machine And Setting Data - Siemens SINUMERIK FM-NC Installation And Startup Manual

03.96
6.1

Machine and setting data

Parameterization
The control system is adapted to the machine by means of machine and setting
data.
Machine data
The machine data (MD) are classified as follows:
S
S
S
S
S
S
Setting data
The setting data (SD) are classified as follows:
S
S
S
Option data
For enabling options. The option data are included in the scope of delivery of
the option concerned.
Overview of
The machine and setting data are classified as follows:
machine and
Table 6-1
setting data
from 1000 to 1799
from 9000 to 9999
from 10000 to 18999
from 19000 to 19999
from 20000 to 28999
from 29000 to 29999
from 30000 to 38999
from 39000 to 39999
from 41000 to 41999
from 42000 to 42999
from 43000 to 43999
from 51000 to 61999
from 62000 to 62999
from 63000 to 63999
References:
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
6 Assigning Parameters to the Control and the PLC Program
General machine data
Channel-specific machine data
Axis-specific machine data
Machine data for operator panel
Machine data for feed drive
Machine data for main spindle drive
General setting data
Channel-specific setting data
Axis-specific setting data
Overview of machine and setting data
Area
Machine data for drives
Machine data for operator panel
General machine data
Reserved
Channel-specific machine data
Reserved
Axis-specific machine data
Reserved
General setting data
Channel-specific data
Axis-specific setting data
General machine data for compile cycles
Channel-specific machine data for compile cycles
Axis-specific machine data for compile cycles
/LIS/, Lists
6.1 Machine and setting data
Designation
6
6-87