Siemens SINUMERIK FM-NC Installation And Startup Manual page 125

03.96
Table 6-17 Speed setpoint filter
No. Identifier
1500 NUM_SPEED_FILTERS[0...7,DRx]
1502 SPEED_FILTER_1_TIME[0...7,DRx]
Table 6-18 Major monitoring and limiting functions
No. Identifier
1145 STALL_TORQUE_REDUCTION[DRx]
1230 TORQUE_LIMIT_1[0...7,DRx]
1239 TORQUE_LIMIT_FOR_SETUP[DRx]
1235 POWER_LIMIT_1[0...7,DRx]
1237 POWER_LIMIT_GENERA TOR[DRx]
1105 MOTOR_MAX_CURRENT_REDUCTION[DRx]
1238 CURRENT_LIMIT[DRx]
1605 SPEEDCTRL_LIMIT_TIME[DRx]
1606 SPEEDCTRL_LIMIT_THRESHOLD[DRx]
1405 MOTOR_SPEED_LIMIT[0...7,DRx]
1420 MOTOR_MAX_SPEED_SETUP[DRx]
1147 SPEED_LIMIT[DRx]
Table 6-19 Important messages
No. Identifier
1417 SPEED_THRESHOLD_X[0...7,DRx]
1418 SPEED_THRESHOLD_MIN[0...7,DRx]
1426 SPEED_DES_EQ_ACT_TOL[0...7,DRx]
1428 TORQUE_THRESHOLD_X[0...7,DRx]
1602 MOTOR_TEMP_WARN_LIMIT[DRx]
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
6 Assigning Parameters to the Control and the PLC Program
Name
Number of speed setpoint filters
Time constant speed setpoint f. 1
Name
Stall torque reduction factor
1st torque limit value
Torque limit for setup mode
1st power limit value
Maximum generator output
Reduction in max. motor current
Current limit value
Timer n controller at limit
Threshold n controller at limit
Motor monitoring speed
Max. motor speed setting-up mode
Speed limitation
Name
nx for 'nact<nx' signal
nmin for 'nact>nmin' signal
Toler. band for 'nset=nact' signal
Threshold torque Mdx
Motor temp. warning threshold
6.9 Axes and spindles
Drive
FDD/MSD
FDD/MSD
Drive
MSD
FDD/MSD
FDD/MSD
FDD/MSD
FDD/MSD
FDD
MSD
FDD/MSD
FDD/MSD
FDD/MSD
FDD/MSD
FDD/MSD
Drive
FDD/MSD
FDD/MSD
FDD/MSD
FDD/MSD
FDD/MSD
6-125
6