Siemens SINUMERIK FM-NC Installation And Startup Manual page 275

12.98
03.96
Note
The replacement hard disk contains neither a Windows operating system nor
the MMC system software.
2. Switch on the PG, insert CD in drive.
3. Switch the control off and on and select start-up mode (press key 6 when
4. Select menu "4 Backup/Restore"
5. Enter password
6. Select menu 1 "Hard disk Backup/restore with ghost"
7. Set parameters for the Norton Ghost program:
Note
If the transfer is interrupted during the restore process, the system on the hard
disk is incomplete. An MMC boot diskette with the MS–DOS  6.X boot and
Norton Ghost is therefore required.
8. After a successful restore, the MMC is booted automatically.
Time required:
for the generation of a compressed disk image =130 MB of a
540 MB hard disk via LPT.
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
11.6 Installing a replacement hard disk (SW 4.4 and higher)
DOS window appears)
– <1> configure ghost parameters:
see above
– <3> Harddisk Restore from <pathname>, mode PARALLEL
* When you select this menu, a message window appears:
You are prompted to check whether the connection
between MMC and PG/PC has been established.
The name of the image file of the MMC
are to be restored is displayed.
* PG/PC:
In a DOS window or at DOS level, enter
the command ghost -lps to start the
Norton Ghost program.
* MMC: "Y"
Start the restore by acknowledging the message window (Yes).
* MMC:
The message window of Norton Ghost appears:
The progress of the data transfer is displayed
The paths are displayed
The volume of data to be transferred is displayed
– <4>Back to previous menu
Return to main menu
approx. 15–20 minutes
11 Data Backup
11-275
11