Siemens SINUMERIK FM-NC Installation And Startup Manual page 235

05.98 05.98
03.96
10.10 Automatic controller setting (only MMC 103, SW 4.3 and higher)
The entries in the "Drive test travel enable" and "Travel range" sections of the
window have the same meaning as for the measuring functions.
The type of adjustment is defined in the "mode" function area.
1. Select in the "Mode" function area the setting type
2. Press the "Start" softkey.
3. Follow the interactive instructions
4. When prompted, press the "OK" softkey.
5. When prompted, press the "NC Start" key.
To optimize further axes, select the axes with the "Axis+" or "Axis–" softkeys
and repeat the procedure starting at step 1.
b) Special case:
The controller setting can be
Changing the
S
parameters
S
S
S
The type of adjustment is defined in the "mode" function area. Three different
variants are available:
S
S
S
Vertical softkeys
"Axis+" softkey:
Selects the next axis to be optimized.
"Axis–" softkey:
Selects the previous axis to be optimized.
"Direct selection" softkey:
Allows direct selection of the axis to be optimized in a dialog window.
"Start" softkey:
Starts the automatic controller setting for the selected axis.
"Stop" softkey:
Stops the automatic controller setting for the selected axis (if a measuring
function is active).
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
"Variant 1".
(see flow chart below, boxes shaded gray).
Caution: When you press NC Start, the axis starts to move!
parameterized,
started,
displayed and
saved.
Variant 1: Standard setting
Variant 2: Setting with critical dynamic response
Variant 3: Setting with good damping
10 Drive Optimization with Start-Up Tool
10
10-235