Trace Function (Sw 4.2 And Higher); Description - Siemens SINUMERIK FM-NC Installation And Startup Manual

10 Drive Optimization with Start-Up Tool

10.8 Trace function (SW 4.2 and higher)

10.8 Trace function (SW 4.2 and higher)
10.8.1

Description

Function
overview
10-222
Note
The trace function can be used only with MMC 102/103 or the start-up tool.
Servo trace function with graphic user interface for checking and monitoring
drive/servo signals and states. You can select measuring signals and set the
measuring parameters with softkeys and dropdown lists. The function is oper-
ated using the mouse or keyboard.
Individual functions of the trace function
S
4 trace buffers with up to 2048 values each
S
Selection of SERVO and 611D signals (in position control cycle)
S
Trace/trigger signals can be set with the absolute address and value mask-
ing.
S
Different trigger conditions to start recording.
Triggering always on trace 1
S
Pretriggering and posttriggering possible
S
Measuring signal display
S
Fixed Y scaling selectable for each trace.
S
Marker function selectable for each trace. Expand function in the time axis.
S
Selective loading and saving of the measuring parameters and traces.
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
 Siemens AG 2000 All Rights Reserved
05.98
03.96