General Preparations; Preconditions - Siemens SINUMERIK FM-NC Installation And Startup Manual

Hide thumbs Also See for SINUMERIK FM-NC:
Table of Contents

Advertisement

General Preparations

1.1

Preconditions

Introduction
This Installation and Start-Up Guide describes the procedure for starting up the
basic control functions including drive-related functions. More detailed informa-
tion about special NCK, MMC, PLC or drive functions can be found in the De-
scriptions of Functions/Manuals (see "Documentation requirements").
Software
You will need the following software to start up the SINUMERIK 840D:
requirements
1. PCIN 4.4 for transmission of data to/from MMC
2. Start-up tool for digital SIMODRIVE 611 (applies only to MMC100)
3. SIMATIC Step7 HiGraph
4. Toolbox for SINUMERIK 840D
5. Applies only to MMC100: Software for creating PLC alarm texts and for
Equipment and
You will need the following equipment and accessories to start up the
accessory
SINUMERIK 840D:
requirements
1. Programming device with MPI interface (PG740)
2. MPI cable for PG740
3. V.24 cable with 9-way connector (female)
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Order no.: 6FX2 060–4AA00–2XB0 (German, English, French), order from:
WK Fürth
Order No. 6FC5 255–jAX00–0AB0, supplies on 3.5" floppies
Order No. 6FC5 252–jAX21–0AB0
Supplied on 3.5" floppies:
– Basic PLC program
– Standard machine data blocks
– NC variable selector
transmission to MMC100 (integrated in MMC 100 system software)
1
1
1-15

Advertisement

Table of Contents
loading

Table of Contents