08.97
03.96
8. Select softkey "Data selection" and the areas to be read out. The area "NC
9. Start reading out (softkey Start) and acknowledge any prompts on the oper-
Note
The SIMATIC HiGraph tools can be used to save PLC area data.
Note filter setting for SDBs!
References:
These tools are useful in ensuring portability of the PLC programs.
Loading archiving
To read in an entire configuration first perform a general reset of the control.
data
1. Set the protection level:
2. Connect the PG/PC to interface X6 on the MMC.
3. Select the "Services" operating area on the MMC. Continue with steps listed
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
active data", for example, contains the following data:
– Machine data
– Setting data
– Option data
– Global and local user data
– Tool and magazine data
– Protection zones
– R parameters
– Zero offsets
– Drive data
– Compensation data
– Display machine data
– Workpieces, global part programs/subroutines
– Standard and user cycles
– Definitions and macros
When the areas are output, the internal area identifier used in each case
appears on the top line of the display.
ator panel.
/S7HT/ Manual, Application of Tools
– up to SW 3.x to "Manufacturer" (password SUNRISE)
– in SW 4 and higher to "User" (password CUSTOMER)
under "Reading in series start-up" or "Reading in area-specific archive data".
11 Data Backup
11.2 Data backup via MMC 100
11
11-251