Siemens SINUMERIK FM-NC Installation And Startup Manual page 237

05.98 05.98
03.96
10.10 Automatic controller setting (only MMC 103, SW 4.3 and higher)
1
Start mech.
measurement
part 2?
SK "OK"
Confirm NC Start prompt
Caution:
When you activate NC Start, the
axis starts to move!
Start mea-
surement
of current
control
loop?
SK "OK"
Confirm NC Start prompt
Caution:
When you activate NC Start, the
axis is operated in current control
mode!
2
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10 Drive Optimization with Start-Up Tool
Enter measur.
SK "Parameter"
parameters
Enter measur.
SK "Parameter"
parameters
SK "Cancel"
(discard
changes)
SK "OK"
(accept
values)
SK "Cancel"
(discard
changes)
SK "OK"
(accept
values)
10-237
10