Siemens SINUMERIK FM-NC Installation And Startup Manual page 293

12.98
03.96
S
S
S
S
S
Note
Please note that the details in the info field are gross figures. Approximately 8%
should be subtracted for management overhead.
S
Note
A card change is detected automatically. The contents of the card (FFS) are
displayed.
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Display card contents:
Click the NC card display with the
sion display of the NC system)
View card info with card and FFS data
Click a free location (not a button, not a display, e.g. top right) with the
mouse button (same effect as menu NC Card/ID Info menu).
The arrows are used in the same way as menu commands:
– Read/write NC system. Below that, read/write FFS system.
– Copy files from the hard disk to the FFS system.
– Copy files from the FFS system to the hard disk.
– Load or save finished FFS systems in RAM image.
List boxes (Explorer)
The list boxes show the available FFS directories on the left, and the con-
tents of the selected directory on the right. Double-click the directory names
to select the directories. Use the "Back arrow" to move back one level. A file
must be selected in the right list field before activating the "Modify file" or
"Delete file" key.
Info field bottom left
After you format the FFS system, the bottom left info field indicates the
formatted memory, and the free capacity as a % number and a byte count.
FFS system detection
If the program is started when a card is inserted, the program detects
whether an FFS system is supported. If no reference data are available for
the FFS start and end address on the card, the system suggests these be
entered automatically as far as possible.
12 Software and Hardware Replacement
12.4 Upgrading the NC
left mouse button (menu: NC card /ver-
right
12
12-293