Siemens SINUMERIK FM-NC Installation And Startup Manual page 71

08.97
03.96
Online change of
Different languages are selected in the "Start-up/MMC/Languages" display (pro-
vided that languages have been loaded). This display provides the user with a
the 2nd language
list of the available languages. The user selects one language and confirms the
selection with "OK". The user can then change over between the first language
and the language just set by selecting the "Change language" softkey in the
"Start-up" display. The 2nd language can always be changed in online mode.
Install language
The languages installed on the MMC102/103 on delivery are English and Ger-
man. The two supplementary packages (1 and 2) are also available.
packages
Supplementary package 1: European languages:
GR
SP
FR
UK
IT
Supplementary package 2: Asian languages:
KO
TW
CH
Definition of
The languages to be used on the MMC are configured in file c:\mmc2\mmc.ini.
usable The required changes in the file described below can be made with the editor
which can be called under Start-up//MMC.
languages
Default setting
Two languages can be configured from the languages listed below:
GR
without activating
SP
logographic
FR
languages
UK
IT
Example:
1st language German, 2nd language English
File MMC.INI must be altered as shown below:
Excerpt from mmc.ini:
...
[LANGUAGE]
Language=GR
LanguageFont=Europe
Language2=UK
LanguageFont2=Europe
...
Note
When editing file MMC.INI, take care to ensure that you change only the high-
lighted (bold print) texts. Make sure that your entries are spelled correctly.
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
3.9 MMC 100/MMC 102/103 operator panel
German (standard)
Spanish
French
English (standard)
Italian
Korean (Korea) pictographic language
Chinese (Taiwan) pictographic language
Chinese (Mandarin) pictographic language
German (standard)
Spanish
French
English (standard)
Italian
3 Settings, MPI / OPI
3-71
3