Siemens SINUMERIK FM-NC Installation And Startup Manual page 243

05.98 05.98
03.96
10.10 Automatic controller setting (only MMC 103, SW 4.3 and higher)
Bandwidth:
Any of the available bandwidths can be selected in order to test the automatic
controller setting.
Averaging:
Influences the quality of the measurement.
Offset:
Input of load velocity in mm/min (should be greater than the amplitude by a
factor of at least 2).
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10 Drive Optimization with Start-Up Tool
J
10
10-243