File Saving Command (The Batch Data Backup) - YASKAWA DX100 Instructions Manual

DX100

3.4.5 File Saving Command (The Batch Data Backup)

Command No. 0x0
Instance 0x0
Attribute 0x0
Service 0x16
32bit integer Byte 0
/
R
M
K
N
Instance 0x96
Status Respond by one in the followings
0x00 : respond normally
•
Other than 0x00
•
Added status size 0: no added status
•
1: 1 WORD
•
2: 2 WORD
•
Added status The error code specified by the
added status size
3 Transmission Procedure
3.4 File Control Command
Request
Sub header part
<Details>
File saving process
Data part
Byte 1 Byte 2 Byte3
S P D
V / C
O S B
. B I
Answer
Sub header part
<Details>
: respond abnormally
"1" indicates 1 WORD of added status data, and "2"
indicates 2 WORD of added status data.
The error code of 1 WORD exists if the added status
code is "1" and that of 2 WORD exists if the code is "2".
Data part
No data part
To set the batch data backup function, set the device as
"RAMDISK" as in advance.
It takes about ten minutes to finish backing-up the data by
NOTE
using the batch data backup function.
Refer to section 2.5 "Setting of a Batch Data Backup
Function" for more detail.
3-93
<Details>
Specify /SPDRV/CMOSBK.BIN
HW1480958
162529-1CD
112 of 119