Ac Peak-To-Peak Voltage; Measurement - Tektronix 2212 User Manual

I ,
Non-Storage Examples
AC Peak-to-Peak Voltage
Measurement
To make a peak-to-peak voltage measurement, see Figure
3-1,
and
use the following procedure:
NOTE
This procedure may also be used to make voltage meas-
urements between any two points on a waveform.
INACTWE
CURSOR
ACTIVE
CURSOR
Figure 3-1: Peak-to-Peak Voltage Waveform Measurement
Step
1.
Switch the 221_2 on and obtain a baseline display in
Non-Store mode.
Step 2. Apply the AC signal to be measured to either
vertical-channel input connector and set the Vertical
MODE to display the channel used.
3 -
2 Measurement Examples