Initial Setup - Tektronix 2212 User Manual

Initial Setup
This tutorial get you started making measurements both in Non-
Store and in Store mode, using the capabilities of the 2212 oscillo-
scope. The following will be discussed in separate chapters:
• Initial Setup
• Making Non-Store (Analog) Displays with the 2212
• Making Store (Digital) Displays with the 2212
Initial Setup
The following procedure will allow you to set up and operate the
instrument to obtain the most commonly used oscilloscope dis-
plays.
Step
1.
Verify that the POWER switch is OFF (switch is in the OUT
position).
Step 2. Plug the power cord into the ac power outlet.
Step 3. Press in the POWER switch (ON) and let the instrument
warm up
(20 minutes is recommended for best accuracy).
Step
4.
Press the AUTO Setup button to obtain a Baseline Display
with the following front panel setup:
2212 User Manual
2-1