Dodge Sprinter 2006 Manual page 750

3 - 10 PROPELLER SHAFT
Fig. 11 BOOT
1 - BOOT
2 - CLAMP
3 - SHAFT
(4) P u ll a pa r t pr opeller sh a ft .
(5) Rem ove sn a p-r in g (F ig. 12).
Fig. 12 CENTER BEARING
1 - SNAP-RING
2 - CENTER BEARING
3 - WASHER
4 - SHAFT
5 - PROTECTIVE CAP
NOTE: If center bearing is equipped with a round
flange remove bolt from the middle of the flange.
(6) P u ll off cen t er bea r in g wit h a Bea r in g Split t er
1130 a n d Br idge 938, wit h a plu g on t h e en d of t h e
sh a ft (F ig. 13).
NOTE: The bearing splitter must be positioned
behind the thrust washer of the bearing.
Fig. 13 CENTER BEARING REMOVAL
1 - BRIDGE
2 - PLUG
3 - BEARING SPLITTER
4 - CENTER BEARING
INSTALLA TION
(1) P r ess cen t er bea r in g on pr opeller sh a ft wit h
pr ot ect ive ca ps a n d wa sh er wit h In st a ller 9275 (F ig.
14).
Fig. 14 CENTER BEARING INSTALLATION
1 - INSTALLER
2 - CENTER BEARING
VA