Dodge Sprinter 2006 Manual page 1045

VA
CONDITION
WIPERS INOPERATIVE IN
HIGH POSITION
WIPERS DO NOT PARK
AFTER OPERATING
WASHERS INOPERATIVE
AUTOMA TIC WIPER SYSTEM
CONDITION
WIPERS INOPERATIVE IN
ALL SWITCH POSITIONS
POSSIBLE CAUSES
1. Faulty high speed circuit.
2. Faulty multi-function switch.
3. Faulty wiper high speed brush.
1. Faulty motor feed circuit.
2. Faulty park switch output circuit.
3. Faulty wiper relay.
4. Faulty park switch.
1. Faulty washer pump ground cir-
cuit.
2. Faulty washer pump feed circuit.
3. Faulty washer pump motor.
4. Faulty muli-function switch.
POSSIBLE CAUSES
1. Faulty or missing fuse.
2. Faulty wiper motor ground circuit.
3. Faulty wiper motor.
4. Faulty multi-function switch feed
circuit.
5. Faulty multi-function switch.
6. Faulty rain sensor control module
ground circuit.
7. Faulty rain sensor control module
feed circuit.
8. Faulty rain sensor control mod-
ule.
WIPERS/WASHERS 8R - 7
CORRECTION
1. Test and repair the open high speed
circuit between the multi-function switch
and the wiper motor as required.
2. Test and replace the multi-function
switch as required.
3. Test and replace the wiper motor as
required.
1. Test and repair the open fused ignition
switch output circuit to the wiper motor as
required.
2. Test and repair the open or shorted cir-
cuit between the wiper park switch and
the wiper relay as required.
3. Test and replace the wiper relay as re-
quired.
4. Test and replace the wiper motor as
required.
1. Test and repair the open ground circuit
as required.
2. Test and repair the open circuit be-
tween the multi-function switch and the
washer pump as required.
3. Test and replace the washer pump as
required.
4. Test and replace the multi-function
switch as required.
CORRECTION
1. Test and replace the fuse as required.
2. Test and repair the open ground circuit
as required.
3. Test and replace the wiper motor as
required.
4. Test and repair the open fused ignition
switch output circuit between the fuse and
the multi-function switch as required.
5. Test and replace the multi-function
switch as required.
6. Test and repair the open ground circuit
as required.
7. Test and repair the open fused ignition
switch output circuit between the fuse and
the rain sensor control module as re-
quired.
8. Test and replace the rain sensor control
module as required.