Removal; Installation - Dodge Sprinter 2006 Manual

VA
• Th e n or m a lly closed t er m in a l (87A) is con n ect ed
t o ba t t er y cu r r en t t h r ou gh a fu sed ign it ion swit ch
ou t pu t cir cu it wh en ever t h e ign it ion swit ch is in t h e
On posit ion .
Th e wiper r ela y ca n be dia gn osed u sin g con ven -
t ion a l dia gn ost ic t ools a n d m et h ods.

REMOVAL

WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, or instrument panel component diagno-
sis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for
the system capacitor to discharge before perform-
ing further diagnosis or service. This is the only
sure way to disable the supplemental restraint sys-
tem. Failure to take the proper precautions could
result in accidental airbag deployment.
(1) Discon n ect a n d isola t e t h e ba t t er y n ega t ive
ca ble.
(2) Rem ove t h e fu se a ccess pa n el fr om t h e st eer in g
colu m n open in g cover below t h e st eer in g colu m n on
t h e in st r u m en t pa n el.
(3) Rea ch t h r ou gh a n d below t h e ou t boa r d side of
t h e fu se a ccess open in g t o a ccess t h e wiper r ela y
(F ig. 34).
Fig. 34 Wiper Relay Remove/Install
1 - FUSE BLOCK
2 - LOWER INSTRUMENT PANEL
3 - STEERING COLUMN COVER
4 - LATCH (2)
5 - WIPER RELAY
(4) Rem ove t h e wiper r ela y by gr a spin g it fir m ly,
r elea sin g t h e la t ch es a n d pu llin g it st r a igh t down
fr om t h e r ecept a cle on t h e bot t om of t h e fu se block.
INSTALLA TION
WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, or instrument panel component diagno-
sis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for
the system capacitor to discharge before perform-
ing further diagnosis or service. This is the only
sure way to disable the supplemental restraint sys-
tem. Failure to take the proper precautions could
result in accidental airbag deployment.
(1) P osit ion t h e wiper r ela y t o t h e r ecept a cle on
t h e bot t om of t h e fu se block (F ig. 34).
(2) Align t h e wiper r ela y t er m in a ls wit h t h e t er m i-
n a l ca vit ies in t h e fu se block r ecept a cle.
(3) P u sh fir m ly a n d even ly on t h e t op of t h e wiper
r ela y u n t il t h e t er m in a ls a r e fu lly sea t ed in t h e t er-
m in a l ca vit ies in t h e r ecept a cle of t h e fu se block a n d
bot h la t ch es a r e fu lly en ga ged.
(4) Rein st a ll t h e fu se a ccess pa n el on t o t h e st eer-
in g colu m n open in g cover below t h e st eer in g colu m n
on t h e in st r u m en t pa n el.
(5) Recon n ect t h e ba t t er y n ega t ive ca ble.
WIPERS/WASHERS 8R - 35