Dodge Sprinter 2006 Manual page 816

5 - 32 BRAKES - ABS
Fig. 3 REAR WHEEL SPEED SENSORS
1 - SHRINK-FIT SLEEVE
2 - SPEED SENSOR
3 - CLAMPING BUSHING
4 - SHRINK TUBE
INSTALLA TION
(1) Con n ect sepa r a t e wh eel speed sen sor ca bles
wit h sh r in k-fit sleeves a n d sh r in k-fit t u bin g (F ig. 3).
On ly d o th is s te p if re p la c in g th e s e n s o r.
(2) In st a ll t h e cla m pin g bu sh in g in t o t h e kn u ckle
(F ig. 3) On ly d o th is s te p if re p la c in g th e s e n s o r
o r th e c la m p in g bu s h in g w a s d a m a g e d .
(3) In st a ll t h e wh eel speed sen sor a ll t h e wa y in t o
t h e a xle t u be, t h e wh eel speed sen sor will self a dju st
wh en t h e veh icle is m oved (F ig. 3).
(4) In st a ll t h e r ea r wh eels.
(5) Lower t h e veh icle.
T ON E WH EEL
REMOVAL
(1) Rem ove t h e h u b/bea r in g
(Refer t o 3 - DIF F E RE NTIAL & DRIVE LINE /RE AR
AXLE /AXLE BE ARINGS - RE MOVAL).
(2) In ser t a h ooked pr yba r bet ween t h e h u b/bea r-
in g a n d t h e in side of t h e t on e wh eel a n d pr y u pwa r ds
sligh t ly a n d wor k you r wa y a r ou n d t h e t on e wh eel
u n t il t h e wh eel is loose (F ig. 4).
(3) Rem ove t h e t on e wh eel.
INSTALLA TION
a t h in bea d of silicon e a r ou n d t h e t on e wh eel.
u n t il sea t ed.
DIF F E RE NTIAL & DRIVE LINE /RE AR AXLE /AXLE
BE ARINGS - INSTALLATION).
ST EERI N G AN GLE SEN SOR
DESCRIPTION
a ssem bly (DRW)
Fig. 4 TONE WHEEL REMOVAL
1 - HOOKED PRYBAR
2 - TONE WHEEL
3 - HUB/BEARING ASSEMBLY
(1) In st a ll t h e t on e wh eel t o t h e h u b/bea r in g wit h
(2) Ta p t h e t on e wh eel down wit h a soft h a m m er
(3) In st a ll t h e h u b/bea r in g (DRW) (Refer t o 3 -
Fig. 5 STEERING ANGLE SENSOR
1 - UPPER STEERING COLUMN COVER
2 - CLOCKSPRING
3 - STEERING ANGLE SENSOR
4 - LOWER STEERING COLUMN COVER
5 - FRONT COVER
6 - STEERING ANGLE SENSOR ELECTRICAL CONNECTION
VA