Dodge Sprinter 2006 Manual page 902

8G - 6 HEA TED GLASS
DEFOGGER SWI T CH CON N ECT OR PI N
CALL-OU T
PIN
1 FUSED B+ (DRL RELAY)
3 IGNITION SWITCH OUTPUT (START-
RUN)
5 PANEL LAMPS DRIVER
7 DEFOGGER SWITCH OUTPUT
9 PANEL LAMPS DRIVER
10 GROUND
REMOVAL
WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, or instrument panel component diagno-
sis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for
the system capacitor to discharge before perform-
ing further diagnosis or service. This is the only
sure way to disable the supplemental restraint sys-
tem. Failure to take the proper precautions could
result in accidental airbag deployment.
(1) Discon n ect a n d isola t e t h e n ega t ive ba t t er y
ca ble.
(2) Rem ove t h e clu st er bezel fr om t h e in st r u m en t
pa n el (F ig. 7) (Refer t o 23 - BODY/INSTRUME NT
PANE L/CLUSTE R BE ZE L - RE MOVAL).
FUNCTION
Fig. 7 Cluster Bezel Remove/Install
1 - SCREWS (2)
2 - CLUSTER BEZEL
3 - REAR WINDOW DEFOGGER SWITCH
4 - DEFOGGER SWITCH CONNECTOR
5 - WIRE HARNESS CONNECTOR
6 - WIRE HARNESS CONNECTOR
(3) F r om t h e ba ck of t h e clu st er bezel, squ eeze t h e
t wo la t ch es on t h e r ea r win dow defogger swit ch body
a n d pu sh t h e swit ch ou t t h r ou gh t h e fa ce of t h e bezel
(F ig. 8).
(4) Rem ove t h e r ea r win dow defogger swit ch fr om
t h e clu st er bezel.
Fig. 8 Headlamp Leveling Switch Remove/Install
1 - SWITCH
2 - LATCH (2)
3 - CLUSTER BEZEL
INSTALLA TION
(1) P osit ion t h e r ea r win dow defogger swit ch t o t h e
pr oper m ou n t in g h ole on t h e fa ce of t h e clu st er bezel.
(2) Usin g h a n d pr essu r e, pu sh t h e r ea r win dow
defogger swit ch fir m ly a n d even ly in t o t h e swit ch
VA