Mazda CX-9 Grand Touring 2009 Manual page 1520

Courtesy of MAZDA MOTORS CORP.
6. Install in the reverse order of removal.
BASS-BOX INSPECTION
1. Verify the resistance between bass-box terminals.
If the resistance is not within the specification, replace the bass-box.
Resistance 4 ohms
2. Connect a 1.5 V battery to the bass-box and verify that noise is heard from the bass-box.
If no noise is heard, replace the bass-box.
Fig. 31: Identifying Bass-Box Terminals
Courtesy of MAZDA MOTORS CORP.
CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
6. Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
7. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
8. Roof side trim (See ROOF SIDE TRIM REMOVAL/INSTALLATION .)
9. Third-row seat belt upper anchor installation bolt (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
10. D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Entertainment - Mazda CX-9