Mazda CX-9 Grand Touring 2009 Manual page 1498

Fig. 144: Identifying No.4 Engine Mount Bolt & Nuts
Courtesy of MAZDA MOTORS CORP.
ENGINE DISASSEMBLY/ASSEMBLY [MZI-3.7]
1. Remove the transaxle from the engine. (See AUTOMATIC TRANSAXLE
REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL] .)
2. Remove the drive plate. (See DRIVE PLATE REMOVAL/INSTALLATION [AW6A-EL, AW6AX-
EL] .)
3. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [MZI-3.7] .)
4. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR
REMOVAL/INSTALLATION [MZI-3.7] .)
5. Remove the power steering oil pump. (See POWER STEERING OIL PUMP
REMOVAL/INSTALLATION .)
6. Remove the generator. (See GENERATOR REMOVAL/INSTALLATION [MZI-3.7] .)
7. Remove the fuel injector and fuel distributor. (See FUEL INJECTOR REMOVAL/INSTALLATION
[MZI-3.7] .)
8. Remove the intake-air system. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-
3.7] .)
9. Remove the exhaust system. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZI-3.7] .)
10. Remove the thermostat case and water hose component. (See THERMOSTAT
REMOVAL/INSTALLATION [MZI-3.7] .)
11. Remove the CHT sensor. (See CYLINDER HEAD TEMPERATURE (CHT) SENSOR
REMOVAL/INSTALLATION [MZI-3.7] .)
12. Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR
REMOVAL/INSTALLATION [MZI-3.7] .)
13. Remove the oil pressure switch. (See OIL PRESSURE INSPECTION [MZI-3.7] .)
14. Remove the oil cooler. (See OIL COOLER REMOVAL/INSTALLATION [MZI-3.7] .)
15. Disassemble in the order indicated in the table.
16. Assemble in the reverse order of disassembly.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Mechanical (MZI-3.7) - Mazda CX-9