Mazda CX-9 Grand Touring 2009 Manual page 1544

2WD
1. Remove the joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION [2WD] .)
2. Remove the WU-TWC (RH).
AWD
1. Remove the joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION [AWD] .)
2. Remove the insulator. (See STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION .)
3. Remove the No.1 engine mount (transaxle side). (See ENGINE REMOVAL/INSTALLATION [MZI-
3.7] .)
4. Push up the engine.
5. Remove the WU-TWC (RH).
EXHAUST MANIFOLD INSULATOR (LH) REMOVAL NOTE
1. Set the fan control module out of the way. (See COOLING FAN COMPONENT
REMOVAL/INSTALLATION [MZI-3.7] .)
2. Remove the exhaust manifold Insulator (LH).
WARM UP THREE WAY CATALYTIC CONVERTER (WU-TWC) (LH) INSTALLATION NOTE
1. Install the WU-TWC (LH) insulator.
2. Temporarily tighten WU-TWC (LH) bracket.
3. Temporarily tighten WU-TWC (LH) bracket (L type) (engine side).
4. Install the WU-TWC (LH).
5. Install the WU-TWC (LH) bracket.
6. Install the WU-TWC (LH) bracket (L type).
WARM UP THREE WAY CATALYTIC CONVERTER (WU-TWC) (RH) INSTALLATION NOTE
2WD
1. Install the WU-TWC (RH) insulator.
2. Temporarily tighten WU-TWC (RH) bracket.
3. Temporarily tighten WU-TWC (RH) bracket (L type) (engine side).
4. Install the WU-TWC (RH).
5. Install the WU-TWC (RH) bracket.
6. Install the WU-TWC (RH) bracket (L type).
AWD
1. Install the WU-TWC (RH) insulator.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Exhaust System (MZI-3.7) - Mazda CX-9