Aileron Installation - Piper PA-24 Comanche Service Manual

AU1
@7
'O~
1.
NUT
2. WASHER
3. SPACER
4 Sl'ACER WASHER
5. BOLT
a.
WING FITTING
7. FLAP FITTlNG
a.
BOLT
t.
TRACK
10. ROLLER. NYLON
PIPER COMANCHE SERVICE MANUAL
•
FIGURE 4·3. FLAP ROLLER INSTALLATION
(ELECTRICALLY OPERATED)
FIGURE
4-...
AIL!RON BEARING
I"STALLATIOH
f. In the
ri&ht
winC, by nteMC
throup
the wbe.l well, draw the flap return step lock cable
and connect. Encace the step lock. In the l.ft willi CODliect the nap retum sprinl.
i·
Check
nap
riainl and adjustments. (Refer to RilPI Of Flap, Seetioa V.)
h. Install acce•• plates aad wheel weU splub pill.
"OTI
When inatl11inl nap roller., poaition apacer wuhera to aUow no
side bindina aad a.certain that the roller bushina' will roll free.
4-26. Installatian Of Flop.
(''''24-400)
a. Ascertain that the nap control rod
~
instaned on the flap.
b. Position the
nap
in place, lubricate the flap roUers aad tracka(Refer to Lubrication Chart.
Section II) and install the lower roUer ...embli••. (Refer to
tip.
4-3.)
c. Swing the nap rearward and install the remaining assemblies. \'love the Hap thzough its
full travel to ascertain that there is no bindina.
d. The right flao. inaert the ste;» loCk cable tbrollch the l••dinl edle.
e. Connect:he flap contml rod to the
~el1crank.
f.
Enter throll&h the riabt wheel well Md connect the step iock return sprina. Engage the
step lock.
I. Check flap riginl and adjustllleftt•. (Refer to R!.a&inl Of Flap, Section V.)
h. Install acc... plates and wheel well splash pan.
4-2i. In'tallation Of AiI.ron.
a. Position the aileron. lubricate (R.fer to Lubrication Chart. Section
II)
and install the in-
board hinge bolt. (Refer to figure 4-4.) Install the outboard bolt. Place the spacer washers to
allow for best alignment of hinges.
~ove
the aileron throuah its full travel to ascertain that there
is no binding.
STRUCTURE
ISSUED: 8/18/72
1
E14
•
•