Electrically Operated Flaps - Piper PA-24 Comanche Service Manual

•
•
•
PIPER COMANCHE SERVICE MANUAL
5-16.
E1ecaic:aUy
Opnud
F1ape.
5-17. Removal Of ElectricaUy Opr:raccd Flap Concrob. (PA-Z4-250 and PA-Z....260.) (Refer to Figure
5-5.)
a. Access for the removal of the flap &etUauftimcchanis.., and flap control cables within the fuselqe
may be reached by mnovin, the reat teat. Access to the controls in the
wiftI
may be reached by removing
the wheel well splash pan and access plate to the flap beUcrank.
b. Remove the flap transmission assembly by disconnecUnc the motor elccmca1lcad$. extracting pin
(19) at the rransmission nOUslnS aDd tcmoving bolt
(23)
at the forward seerion of the aem.tin, screw.
c. Ac:ru.atinl
arms
(14 and 15)
aft
removed by cliIConnCC'tinl concrol tabla (2 IDd 5) at the a.rms. the
flap position scndCT rod and rcmovin, the pivot bolt at the tOP
spar
SUP1'ort Nbc.
d. To remove the control cable (2) located
in
the fucJaae. remOl/C the cable pwlcy(s) and disconnect
tumbuckle (46) located inside the fuse• • On the PA-Z4-180, PA-2.... 2 50. PA-Z4-260, Serial
S05.
24-4000
to 24-4246, 24-4248 to 24-4299 disconnect tension
SPrinl
(42) with left tumbuck1e.
c.
The control cable located in the wing may be removed by ellccrinJ throup the wneel well and
removing the cable pulley. Disconnect the cable
at
the beUcrank and dn.w the cable through the fuselage
Of
wheel weU.
f. To tcmove tbe beUcn.nk. disconnect the flap control
rod
(33) and bcllcrank mum spring
(4) at
the bcUcnnk. remove the bolt
securing
the belletank.
g. To remove the left flap mum cable, enter tbroush the wheel well and dilconnett the cable spring
(43)
at the inboard side of the wheel well. DiIeonDeet the other
CDd
at the lcadi",
cdcc
of the flap.
h. Removal of the riPt flap mum cable and
st~
lock mechanism is accomplished by disconnecting
the
1'CtUtn
spring (43) at the inboard side of wheel well. Remove the aft
winJ fairinI.
the access plate
located
at
the inboard. under side of flap. and baclt the
adjustiDg
nut
(41)
off the cable
CDd..
Unbolt step
lock pulley mechanism (44) and withdraw support cable.
SURFACE CONTROLS
ISSUED: 8/1Sn2
IG9