Table of Contents
Advertisement
P!PER COMANCHE SERVICE MANUAL
NOTE
In the event that the lower rudder attachment bracket is ever removed
or replaced. insuJl the four attachment bola with the heads toward the
front of the airc:ra:ft.
4-35. InataU.llion Of Scabilator.
a.
Slip the left stabilator on the stabilator torque tube and
aliIn
twO
holes in the stabilator with holes
in the torque tube.
b. Secure the stabilator with two bola.
c.
Install
the right nabilator in a
similar
manner as the left stabilator.
d.
Connect inboll'd tt&ili,. edges of the left and ",ht stabilator and iftl'Call the bolt.
e.
Attach the stabilator trim rod
~o
the stabilator trim tabs and iNU1l the bolt.
f.
If subiJator leadin,
cdJe JUd are
installed. check to
see
that reU'
edges
of IUlI'ds fit stlbilator
contour without any wrinkles or pps.
NOTE
Rig Empcnnace Group as described in Section
V
of this manual.
•
4-36. Installation Of Tail Fairinp.
a..
Install the
fm
root fairing.
b.
Connect the quick-disconnect fircm, on the
tail
light
wire
before posiQoniD( the tail cone
uscmbly onto the fuselage rear bulkhead.
c.
Attach the tail cone fairing.
olo-31.
InsuU.rion
Of Fusa.,e
Componena.
•
+38. Replacement Of Windlftield. The windshield on the PA·24 consists of two sections which may be
replaced as follows:
a..
Remove windshield outside collar fairin, by removing attaching screws.
b.
Remove windshield divider mip by removing attaching machine screws and nuts.
c.
Remove left or right upper interior windshield
trim
panel by removinJ attaching scrcws.
d.
Remove left or richt interior fairing from windshield post.
e.
Windshield can now be removed by pulling it out from channels.
NOTE
A damaged windshield should be saved since it CLn be used as a pattern
for drilling holes in a new windshield.
f.
Grind new windshield to fit in windshield channels and grind half holes for screws to fit in
windshield divider strip.
g.
Apply black electrical tape. Prntite number 163. over edges of windshield.
h.
Apply .125 inch 3M Sealer number 1126. manufactured bv Minnesota
~\ining
Mfg. Company.
between windshield and channeis.
I.
Install new Windshield in windshield channels Ind allow .125 inch clearance bccween two sectiOns
of windshield at divider POSt to aJlow for e:orpansion.
J:
Install windshield collar.
STRUCTURE
ISSUED: 8/18/72
1
E16
•
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
