Landing Light And Housing Installation; Heated Pitot Tube; Fin Installation; Rudder Installation - Piper PA-24 Comanche Service Manual

•
•
•
PIPER COMANCHE SERVICE MANUAL
b. Connect the aileron control
rod.
c. Check liging and
adjustmel~t'li.
(Refer to Rillillg Of Aileron, Section V.)
d. Install the access plate to the aileron beUcrlllk.
4-28. Installation Of LoncUn, Li,ht And Hou'in,.
a. Install the landing lipt hOlding. s.cunnl with screw. io each comer.
b. Connect the electrical leads to the back of the lamp and secure the lamp to the lDOWlting
bracket. Ascertain that the lamp will licht.
c. Install the landil1llipt window.
4-29. 'nstollettion Of Win, Tip.
•. Connect the electrical leads. Aseertain that the position lipt will operate.
b. Place the winl tip on the winl. start all screws. then tichten.
4-30. Standard Pltot Tub•. Attach the pitot and static lines to pitot tube ..sembly and illStall
the pitot tube assembly to the bottom of the left wine panel.
4-31. H.ot.el Pitot Tube.
a. Connect the quick·disconnect Cittin, on the wire for the heated pUot tube
to
the u.ociated
wine wires.
b.
Attach the heated pitot tube assembly to the pitot tube mounting
lIt••
t on the bottom skin
of the left wing plIleI.
4-32. Installotion
Of
Ernp.nna,•.
4-33. Installettlon Of Fin_
a. Position the
fin
on the top of the fu.elace aft section and aUgn the holes in the front
anachment plate with the hole. in the front attachment plate
Oft
the fuselaee. Alien the holes in
the rear :nountinc bracket of the fin with the holes in the rear attachment plate on the fuselage.
b. Install the bolts and screws on the forward anachmeDt plate and on the rear mountine
bracket of the fin assembly.
c. Install the receiver antenna in the fin tip if the radio equipment is installed in the air·
piane.
d. Connect the receiver coaxial cable to the root of the fin ...embly if the receiver antenna
is installed on the fin.
e. Connect the overhead sensinc antenna between the fin assembly and tbe insulator on the
top of the fuselaee center section.
NOTE
The fin should be vertical and in line with the centerline of the
iuselage.
-+-34. Installation Of Rudel.r.
a. Align the two hinge brackets on the rudder with the hinees on the rear spar of the fin
and install the two hinee bolts.
b. Connect the rudder hom to the
~udder
hinge bracket on the fuselage with a clevis bolt.
c. Connect the two rudder control cables to the rudder hom with clevis bolts.
STRUCTURe
ISSUED: 8118172
1E15