Piper PA-24 Comanche Service Manual page 342

PIPER COMANCHE SERVICE MANUAL
r.
SPINNER
2. _LAO£
3. WASHER
4. SIlINNER
AD~OR
RING
5. ENGINE STARTER GEAR
I.IOLT
7. WASHER
I. HUI MOUNTING IOLT
8. NUT
10. "0"
RING
SEAL
11. PROPELLER MOUNTING SHIM
FIGURE 7A·J. PROPELLER INSTALLATION (HARTZELL) PA·24-250
i.-\.-15. Removal Of Propeller. (Hanzell) (PA-24-250) (Reier to Figure
7A-3 )
NOTE
In some maMer identify the position of each part in relation to the
other to facilitate installation.
a. Ascertain that the muter switch and mqnetO switches
ate
in
the OFF position.
b. Remove the spinner
(1)
by removing the screws that secure it to the spinner bulkhead
(~).
c. Place a dnp pan under the propeller to catch oil spillqe.
d. Cut the safety wire around the propeller mounanl bolts (8) and remove them from the
engtn~
crankshaft flange .
.:. Pull the propeller from the engine crankshaft.
f.
Remove the
propeller "0"
ring (10) and shim
(11)
from the engIne flange:
g.
The spinner bulkhead
(~)
may be removed irom the starter nng gear (8) by removing nuts. washers
and bolts.
POWER PLANT
!SSUED: 8/18/72
2
Cl0
•
•
•