Table of Contents
Advertisement
6.2.3
Loop cable connection
The loop cable is used to connect the receiver unit with the emitter unit. It consists of optical
fiber, two electric wires (2 x 0.5 mm
grounding wire (green yellow). For proper operation, use only the loop cable supplied by
Siemens. Please follow the step-by-step instructions (Page 34) for correct installation.
①
②
③
Emitter unit <-> Receiver connection with loop cable. The
connection of the grounding wire is not shown in the diagram.
SITRANS TDL
Compact Operating Instructions, 05\2023, A5E51659183-AA – revised 03/2024
Power supply and sychronization (twisted pair)
Grounding wire
Fiber cable (SMA connector)
(20 AWG)) for power supply, synchronization and a
2
Connecting
6.2 Connecting SITRANS TDL
33
Advertisement
Table of Contents
