Connecting; Basic Safety Notes - Siemens SITRANS TDL Compact Operating Instructions

Connecting

6.1

Basic safety notes

Unsuitable cables, cable glands and/or plugs
• Use only cable glands/plugs that comply with the requirements for the relevant type of
• Close unused cable inlets for the electrical connections.
• When replacing cable glands, only use cable glands of the same type.
• After installation, check that the cables are seated firmly.
Hazardous contact voltage
Risk of electric shock in case of incorrect connection.
• For the electrical connection specifications, refer to the information in Technical
• At the mounting location of the device observe the applicable directives and laws for
Missing PE/ground connection
Risk of electric shock.
Depending on the device version, connect the power supply as follows:
• Power plug: Ensure that the used socket has a PE/ground conductor connection. Check
• Connecting terminals: Connect the terminals according to the terminal connection
Improper power supply
• Connect the device in accordance with the specified power supply and signal circuits.
28
WARNING
protection.
WARNING
specifications (Page 52).
installation of electrical power installations with rated voltages below 1000 V.
WARNING
that the PE/ground conductor connection of the socket and power plug match each
other.
diagram. First connect the PE/ground conductor.
WARNING
The relevant specifications can be found in the certificates, in Technical specifications
(Page 52) or on the nameplate.
Compact Operating Instructions, 05\2023, A5E51659183-AA – revised 03/2024
6
SITRANS TDL