Configure Digital Communications; Configure Hart/Bell 202 Communications - Emerson Micro Motion 1700 Configuration And Use Manual

Integrate the meter with the control system
Options for Enhanced Event Action
Action
Standard
None (default)
Start sensor zero
Start/stop all totalizers
Reset mass total
Reset volume total
Reset gas standard volume
total
Reset all totals
Meter verification
Start meter verification test
Note
Before assigning actions to an enhanced event, check the status of the event. If it is ON, all assigned
actions will be performed when the new configuration is implemented. If this is not accepatable,
wait until an appropriate time to assign actions to the event.
6.6

Configure digital communications

The digital communications parameters control how the transmitter will communicate
using digital communications.
Your transmitter supports the following types of digital communications:
•
•
•
•
Note
The service port responds automatically to a wide range of connection requests. It is not
configurable.
6.6.1

Configure HART/Bell 202 communications

HART/Bell 202 communications parameters support HART communications with the
transmitter's primary mA terminals over a HART/Bell 202 network.
90
Display
NONE
START ZERO
START STOP
RESET MASS
RESET VOL
RESET GSVT
RESET ALL
START VERFY
HART/Bell 202 over the primary mA terminals
HART/RS-485 over the RS-485 terminals
Modbus/RS-485 over the RS-485 terminals
Modbus RTU via the service port
Label
ProLink III
None
Start Sensor Zero
Start/Stop All Totalization
Reset Mass Total
Reset Volume Total
Reset Gas Std Volume Total
Reset All Totals
Start Meter Verification
Micro Motion Model 1700 Transmitters with Analog Outputs
Field Communicator
None
Perform auto zero
Start/stop totals
Reset mass total
Reset volume total
Reset gas standard volume total
Reset totals
Not available