Emerson Micro Motion 1700 Configuration And Use Manual page 245

Modification type
Adjustment
Configuration and Use Manual
Change
• Sensors that are not straight tube sensors are now correctly
identified
• The mA Output fixed alert is now set
• The Factory Configuration Invalid status bit is now set cor-
rectly when connected to a 700 core processor — as the 700
core processor does not support saving and restoring the fac-
tory configuration
• Enabling a new feature on a flow-only device does not reset
the output configuration to factory defaults
• Polled variables are now converted to the transmitter units
before being used
• HART Primary, Secondary, and Tertiary Variables can be
changed using HART when the transmitter is configured for
gas standard volume
• Petroleum measurement variables are removed from the dis-
play when petroleum measurement is disabled
• The mA Output can be fixed when assigned to a concentra-
tion measurement, petroleum measurement, or GSV variable
when the transmitter is not connected to a core processor
• The units for concentration curve data are correctly conver-
ted when the data is entered using HART
• Meter verification failed and aborted alerts are now reflected
in the HART More Status flag
• The HART Squawk command is functional when the HART
write protect is enabled
• Locking the transmitter, unlocking the transmitter, or chang-
ing write protection does not set the HART Configuration
Changed flag
• If connected to a 700 core processor with software version
3.1 or earlier, there is no longer a core processor write failed
alert when setting volume flow units to beer barrels per time
unit
• The factory zero value is immediately updated from the core
processor after running a zero calibration and saving the fac-
tory configuration
• A firmware upgrade done without clearing non-volatile mem-
ory no longer causes an EEPROM Failure alert
• The status bit for the undefined A141 alert (Device Data Cap-
ture Triggered) no longer appears in the Modbus status regis-
ter
• When using AMS to configure the transmitter:
- Changing the output configuration for mA 1, mA 2, or the
Frequency Output, does not change the configuration of
all three outputs
- mA configuration methods can be cancelled
- Density and temperature units display on the concentra-
tion measurement configuration page
NE 53 history
237