Emerson Micro Motion 1700 Configuration And Use Manual page 223

8.
Configuration and Use Manual
Select Connect.
Need help? If an error message appears:
• Verify the Modbus address of the transmitter.
• Ensure that you have specified the correct port on your PC.
• Check the wiring between the PC and the transmitter.
• Increase or decrease resistance.
• For long-distance communication, or if noise from an external source interferes with the
signal, install 120-Ω ½-W terminating resistors in parallel with the output at both ends of
the communication segment.
• Ensure that there is no concurrent Modbus communication to the transmitter.
Using ProLink III with the transmitter
215