Access And Use The Display Menu System - Emerson Micro Motion 1700 Configuration And Use Manual

Table A-1:
Optical switch indicator
Solid red
Flickering red
A.3

Access and use the display menu system

The display menu system is used to perform various configuration, administrative, and
maintenance tasks.
Tip
The display menu system does not provide complete configuration, administrative, or maintenance
functions. For complete transmitter management, you must use another communications tool.
Prerequisites
To access the display menu system, operator access to either the Off-Line menu or the
Alert menu must be enabled. To access the complete menu system, operator access must
be enabled for both the Off-Line menu and the Alert menu.
Procedure
1.
2.
Configuration and Use Manual
Optical switch indicator and optical switch states
At the transmitter display, activate theScroll and Select optical switches
simultaneously until the display changes.
You will enter the Off-Line menu at any of several locations, depending on several
factors.
• If an alert is active and access to the Alert menu is enabled, you will see SEE
ALARM.
• If no alert is active and Smart Meter Verification is enabled on the transmitter,
you will see ENTER METER VERFY.
• If no alert is active and Smart Meter Verification is not enabled on the
transmitter, you will see OFF-LINE MAINT.
If CODE? appears on the display when you make a choice, enter the value that is
configured for Off-Line Password.
a. With the cursor flashing on the first digit, activate Scroll until the correct digit is
displayed, then activate Select.
b. Repeat this process for the second, third, and fourth digits.
Tip
If you do not know the correct value for Off-Line Password, wait 30 seconds. The password
screen will time out automatically and you will be returned to the previous screen.
State of optical switches
One optical switch is activated.
Both optical switches are activated.
Using the transmitter display
191