Emerson Micro Motion 1700 Configuration And Use Manual page 221

Figure B-7: Connection to transmitter terminals
A
A. Computer
B. Signal converter
C. Transmitter, with wiring compartment and power supply compartment opened
Note
This figure shows a serial port connection. USB connections are also supported.
3.
Configuration and Use Manual
a. Remove the transmitter end-cap to access the wiring compartment.
b. Connect the leads from the signal converter to terminals 5 (RS-485/A) and 6
(RS-485/B).
Tip
Usually, but not always, the black lead is RS-485/A and the red lead is RS-485/B.
To connect over the RS-485 network:
a. Attach the leads from the signal converter to any point on the network.
Using ProLink III with the transmitter
C
B
213