Emerson Micro Motion 1700 Configuration And Use Manual page 195

4.
5.
Configuration and Use Manual
c. Gently lift the transmitter straight up, disengaging it from the cap screws.
If you have a 9-wire remote installation:
a. Remove the end-cap.
Figure 10-3: 9-wire remote installation components
A. Transmitter
B. Core processor
C. 4 x cap screws (4 mm)
D. End‐cap
b. Inside the core processor housing, loosen the three screws that hold the core
processor mounting plate in place.
Do not remove the screws.
c. Rotate the mounting plate so that the screws are in the unlocked position.
d. Holding the tab on the mounting plate, slowly lower the mounting plate so that
the top of the core processor is visible.
At the core processor, disconnect the 4-wire cable between the core processor and
the transmitter.
A
B
C
D
Troubleshooting
187