Menu System - Emerson Rosemount 1057 Instruction Manual

Instruction Manual
LIQ-MAN-1057
4.3.4 Formatting the Main Display
The main display screen can be programmed to show primary process variables, secondary process
variables and diagnostics.
1.
2.
3.
4.
5.
6.
For single sensor configurations, the default display shows the live process measurement in the upper
display area and temperature in the center display area. The user can select to disable the display of
temperature in the center display area using the Main Format function. See
through programming the main display to select process parameters and diagnostics of your choice.
For dual sensor configurations, the default display shows Sensor 1 live process measurement in the
display area one and Sensor 2 live process measurement temperature in the display area two.
See Figure 4-1
diagnostics of your choice.
4.4

Menu System

Model 1057 uses a scroll and select menu system. Pressing the
MENU key at any time opens the top-level menu including
Calibrate, Hold, Program and Display functions.
To find a menu item, scroll with the up and down keys until the
item is highlighted. Continue to scroll and select menu items
until the desired function is chosen. To select the item, press
ENTER. To return to a previous menu level or to enable the main
live display, press the EXIT key repeatedly. To return
immediately to the main display from any menu level, simply
press MENU then EXIT.
The selection keys have the following functions:
•
•
•
•
To access desired menu functions, use the
main display format and Quick Start), the live process measurements and secondary measurement values
are displayed in the top two lines of the upper display area. This conveniently allows display of the live values
during important calibration and programming operations.
Menu screens will time out after two minutes and return to the main live display.
Section 4: Display and Operation
Press MENU.
Scroll down to Display. Press ENTER.
Main Format is highlighted. Press ENTER.
The Sensor 1 process value is highlighted in reverse video. Press the selection keys to
navigate down to the screen sections that you wish to program. Press ENTER.
Choose the desired display parameter or diagnostic for each of the four display sections in the
lower screen.
Continue to navigate and program all desired screen sections. Press MENU and EXIT. The
screen returns to the main display.
to guide you through programming the main display to select process parameters and
The Up key (above ENTER) increments numerical values, moves the decimal place one place
to the right, or selects units of measurement.
The Down key (below ENTER) decrements numerical values, moves the decimal place one place to
the left, or selects units of measurement
The Left key (left of ENTER) moves the cursor to the left.
The Right key (right of ENTER) moves the cursor to the right.
Quick Reference Figure B. During all menu displays (except
Section 4: Display and Operation
Figure 4-1 to guide you
April 2017
19