Leica TPS1200 Series Reference Manual page 46

GeoCOM Reference Manual
7.4.2 AUT_SetTol - setting the positioning tolerances
AUT_SetTol........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 9007
9007 ................................................................................................................................................................................................................................................................AUT_SetTol
C-Declaration
AUT_SetTol(AUT_POSTOL
VB-Declaration
VB_AUT_SetTol(TolPar As AUT_POSTOL)
ASCII-Request
%R1Q,9007:ToleranceHz[double], Tolerance V[double]
ASCII-Response
%R1P,0,0:RC
Remarks
This command sets new values for the positioning tolerances of the Hz- and V- instrument axes. This command
is valid for motorized instruments only.
The tolerances must be in the range of 1[cc] ( =1.57079 E-06[
Note: The maximum resolution of the angle measurement system depends on the instrument accuracy class. If
smaller positioning tolerances are required, the positioning time can increase drastically.
Parameters
TolPar
Return-Code Names and Return-Code Values
GRC_OK
GRC_NA
GRC_IVPARAM
GRC_MOT_UNREADY
See Also
AUT_ReadTol
Example
see
AUT_ReadTol
Leica TPS1200 / TS30 / TM30 – Version 1.50
TolPar)
in
The values for the positioning tolerances in Hz and V
direction [
0 Execution successful.
27 GeoCOM Robotic license key not available.
2 One or both tolerance values not within the boundaries
(1.57079E-06[
to 1.57079E-04[
1792 Instrument has no motorization
] ) to 100[cc] ( =1.57079 E-04[
rad
].
rad
] =1[cc]
rad
] =100[cc]).
rad
Automation - AUT
] ).
rad
46