Leica TPS1200 Series Reference Manual page 183

GeoCOM Reference Manual
17.8.5 TMC_SetEdmMode - setting EDM measurement modes
TMC_SetEdmMode ........................................................................................................................................................................................................................................................................... ................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 2020
2020 ................................................................................................................................................................................................................................................................TMC_SetEdmM ode
C-Declaration
TMC_SetEdmMode(EDM_MODE Mode)
VB-Declaration
VB_TMC_SetEdmMode(ByVal Mode As Long)
ASCII-Request
%R1Q,2020:Mode[long]
ASCII-Response
%R1P,0,0:RC
Remarks
This function sets the current measurement mode. The measure function
uses this configuration.
Parameters
Mode
Return-Code Names and Return-Code Values
GRC_OK
GRC_TMC_BUSY
See Also
TMC_GetEdmMode
TMC_DoMeasure
Example
see
TMC_GetEdmMode
Leica TPS1200 – Version 1.50
Theodolite Measurement and Calculation – TMC
In EDM measurement mode.
0 Execution successful.
1293 TMC resource is locked respectively TMC task is busy. The
EDM mode is not set.
Repeat measurement.
TMC_DoMeasure(TMC_DEF_DIST)
183