GeoCOM Reference Manual
8.3.14
BAP_GetATRSetting – getting the current ATR low vis mode
BAP_GetPrismType2.............................................................................................................................................................................................................................................................................
............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 17031
17031...............................................................................................................................................................................................................................................................BAP_GetPrismT
ype2
C-Declaration
BAP_GetATRSetting(BAP_ATRSETTING &reATRSetting)
VB-Declaration
VB_BAP_GetATRSetting(reATRSetting As Long)
ASCII-Request
%R1Q,17034:
ASCII-Response
%R1Q,0,0:RC, reATRSetting[long]
Remarks
Gets the current low vis mode.
Parameters
reATRSetting
Return-Code Names and Return-Code Values
GRC_OK
See Also
BAP_SetATRSetting()
Example
-
Leica TPS1200 / TS30 / TM30 – Version 1.50
Out
BAP_LOWVIS_NORMAL:
ATR is using no special flags/modes
BAP_LOWVIS_ON:
ATR low vis mode on
BAP_LOWVIS_ALWAYSON:
ATR low vis mode always on
BAP_LOWVIS_BOBBYON:
ATR high reflectivity mode on
BAP_LOWVIS_BOBBYALWAYSON:
ATR high reflectivity mode always on
0
Execution successful.
Basic Applications – BAP
85