Measurement Functions - Leica TPS1200 Series Reference Manual

GeoCOM Reference Manual

17.4 MEASUREMENT FUNCTIONS

17.4.1 TMC_GetCoordinate - getting the coordinates of a measured point
TMC_GetCoordinate.................................................................................................................................................................................................................................................................. ............ ............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 2082
2082 ................................................................................................................................................................................................................................................................TMC_GetCoord inate
C-Declaration
TMC_GetCoordinate(SYSTIME WaitTime,
VB-Declaration
VB_TMC_GetCoordinate1(ByVal WaitTime As Long,
ASCII-Request
%R1Q,2082:WaitTime[long],Mode[long]
ASCII-Response
%R1P,0,0:RC,E[double],N[double],H[double],CoordTime[long],
E-Cont[double],N-Cont[double],H-Cont[double],CoordContTime[long]
Remarks
This function queries an angle measurement and, in dependence of the selected
measurement and calculates the co-ordinates of the measured point with an already measured distance. A
distance measurement has to be started in advance. The
measurement to finish. Single and tracking measurements are supported. Information about a missing distance
measurement and other information about the quality of the result is returned in the return- code.
Parameters
WaitTime
Coordinate
Mode
Return-Code Names and Return-Code Values
GRC_OK
GRC_TMC_ACCURACY_GUARANTEE
GRC_TMC_NO_FULL_CORRECTION
GRC_TMC_ANGLE_OK
GRC_TMC_ANGLE_NO_ACC_
GUARANTY
GRC_TMC_ANGLE_NO_FULL_
CORRECTION
GRC_TMC_DIST_ERROR
GRC_TMC_DIST_PPM
GRC_TMC_ANGLE_ERROR
Leica TPS1200 – Version 1.50
TMC_COORDINATE &Coordinate,
TMC_INCLINE_PRG Mode)
Coordinate As TMC_COORDINATE,
ByVal Mode As Long)
In
Out
In
0
1284
1283
1285
1289
1288
1292
1291
1290
Theodolite Measurement and Calculation – TMC
is a delay to wait for the distance
WaitTime
The delay to wait for the distance measurement to finish
[ms].
Calculated Cartesian co-ordinates.
Inclination sensor measurement mode
Execution successful.
Accuracy is not guaranteed, because the result is containing
measurement data which accuracy could not be verified by
the system. Co-ordinates are available.
The results are not corrected by all active sensors. Co-
ordinates are available.
In order to secure which correction is missing use the both
functions
TMC_IfDataAzeCorrError
TMC_IfDataIncCorrError
Angle values okay, but no valid distance. Co-ordinates are
not available.
Only the angle measurement is valid but its accuracy cannot
be guaranteed (the tilt measurement is not available).
No distance data available but angle data are valid. The return
code is equivalent to the
and relates to the angle data. Co-ordinates are not available.
Perform a distance measurement first before you call this
function.
No measuring, because of missing target point, co-ordinates
are not available.
Aim target point and try it again
No distance measurement respectively no distance data
because of wrong EDM settings. Co-ordinates are not
available.
Angle or inclination measurement error. Check inclination
modes in commands.
, an inclination
Mode
and
GRC_TMC_NO_FULL_CORRECTION
144