GeoCOM Reference Manual
17.8.9
TMC_SetAngSwitch - enabling/disabling the angle corrections
TMC_SetAngSwitch..............................................................................................................................................................................................................................................................................
............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................ 2016
2016 ................................................................................................................................................................................................................................................................TMC_SetAngSw
itch
C-Declaration
TMC_SetAngSwitch(TMC_ANG_SWITCH Switch)
VB-Declaration
VB_TMC_SetAngSwitch(ByVal Switch As TMC_ANG_SWITCH)
ASCII-Request
%R1Q,2016:InclineCorr[long],StandAxisCorr[long],
CollimationCorr[long],TiltAxisCorr[long]
ASCII-Response
%R1P,0,0:RC
Remarks
With this function you can enable/disable the following angle measurement corrections.
incline:
stand axis:
collimation:
tilt axis:
Parameters
Switch
Return-Code Names and Return-Code Values
GRC_OK
GRC_TMC_BUSY
See-Also
TMC_DoMeasure
TMC_GetAngSwitch
Example
See example TMC_QuickDist
Leica TPS1200 – Version 1.50
The inclination will be considered for the angle
measurement if enabled.
The standard axis correction will be considered for the
angle measurement if enabled.
The collimation will be considered for the angle
measurement if enabled
The tilt axis will be considered in the angle
measurement if enabled.
0
1293
Theodolite Measurement and Calculation – TMC
Angle measurement corrections
Execution successful.
TMC resource is locked respectively TMC task is busy or a
distance exists.
Clear distance and try it again.
189