Crankshaft Position Sensor-2.0/2.4 L; Crankshaft Position Sensor-2.5L - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

CRANKSHAFT DISTRIBUTOR GENERATOR OIL FILTER POSITION SENSOR HOLD DOWN BOLT
JA
REMOVAL AND INSTALLATION (Continued)
CRANKSHAFT POSITION SENSOR—2.0/2.4 L
The crankshaft position sensor mounts to the
engine block behind the generator, just above the oil
filter (Fig. 51).
REMOVAL
(1) Disconnect electrical connector from crankshaft
position sensor.
(2) Remove sensor mounting screw. Remove sensor.
INSTALLATION
(1) Reverse procedure for installation.
Fig. 51 Crankshaft Position Sensor—2.0/2.4L
CRANKSHAFT POSITION SENSOR—2.5L
REMOVAL
(1) Remove speed control servo from driver's side
strut tower.
(2) Remove crankshaft position sensor retaining
bolt (Fig. 52).
Fig. 52 Crankshaft Position Sensor
(3) Pull crankshaft position sensor straight up out
of the transaxle housing.
CRANKSHAFT POSITION SENSOR
cal connector from the wiring harness connector.
INSTALLATION—ADJUSTABLE
crankshaft position sensor. This can be identified by
an elongated mounting hole in the sensor.
NOTE: If the removed sensor is to be reinstalled,
clean off the old spacer on the sensor face. A NEW
SPACER must be attached to the sensor face before
installation. If the sensor is being replaced, confirm
that the paper spacer is attached to the face of the
new sensor (Fig. 53).
down until contact is made with the drive plate.
While holding the sensor in this position, install and
tighten the retaining bolt to 12 N·m (105 in. lbs.)
torque.
connector to the wiring harness connector.
N·m (80 in. lbs.) torque.
DISTRIBUTOR—2.5L
REMOVAL
intake manifold.
cleaner housing.
tube.
cleaner cover.
PUSH ON CLIP ADJUSTMENT HOLE
IGNITION SYSTEM
(4) (Disconnect crankshaft position sensor electri-
All vehicles will be equipped with an adjustable
Fig. 53 Crankshaft Position Sensor and Spacer
(1) Install sensor in transaxle and push sensor
(2) Connect crankshaft position sensor electrical
(3) Attach connector to heater tube bracket.
(4) Install speed control servo. Tighten nuts to 9
(1) Remove bolt holding air inlet resonator to
(2) Loosen clamps holding air cleaner cover to air
(3) Remove PCV make-up air hose from air inlet
(4) Loosen hose clamp at throttle body.
(5) Remove air inlet tube, resonator and air
(6) Remove EGR tube.
(7) Remove spark plug cables from distributor cap.
PAPER SPACER POSITION SEN- CRANKSHAFT SOR
8D - 23