Camshaft Position Sensor-Dohc - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

CAMSHAFT POSITION SEN- SOR
8D - 22 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
The target magnet has two locating dowels that fit
into machined locating holes in end of the camshaft.
(1) Install target magnet in end of camshaft.
Tighten mounting screw to 3.4 N·m (30 in. lbs.)
torque.
(2) Install camshaft position sensor. Tighten sensor
mounting screws to 9 N·m (80 in. lbs.) torque.
(3) Place brake booster hose and electrical harness
in holders on end of valve cover.
(4) Attach electrical connectors to coolant tempera-
ture sensor and camshaft position sensor.
(5) Install air cleaner inlet tube and filtered air
tube.
CAMSHAFT POSITION SENSOR—DOHC
The camshaft position sensor is mounted to the
rear of the cylinder head (Fig. 48).
Fig. 48 Camshaft Position Sensor Location—DOHC
REMOVAL
(1) Remove filtered air tube from the throttle body
and air cleaner housing.
(2) Disconnect electrical connector from camshaft
position sensor.
(3) Remove camshaft position sensor mounting
screws. Remove sensor.
MOUNTINGBOLT
LOCATING
HOLES (2)
(4) Loosen screw attaching target magnet to rear
of camshaft (Fig. 49).
Fig. 49 Target Magnet Removal/Installation
INSTALLATION
The target magnet has locating dowels that fit into
machined locating holes in the end of the camshaft
(Fig. 50).
Fig. 50 Target Magnet Installation
(1) Install target magnet in end of camshaft.
Tighten mounting screw to 3 N·m (30 in. lbs.) torque.
(2) Install camshaft position sensor. Tighten sensor
mounting screws to 9 N·m (80 in. lbs.) torque.
(3) Carefully attach electrical connector to cam-
shaft position sensor. Installation at an angle may
damage the sensor pins.
(4) Install filtered air tube. Tighten clamps to 3
N·m 1 (25 in. lbs.
LOCATING DOWELS TARGET MAGNET
5) torque.
JA