Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 150

CENTER CONSOLE KNOB ALLEN WRENCH SHIFT KNOB
JA
REMOVAL AND INSTALLATION (Continued)
(2) If vehicle is equipped with an automatic trans-
mission remove the shift knob from the shifter. The
gear shift knob is attached to the shifter using a set
screw (Fig. 136). Access to the set screw is from the
front of the shift knob and is removed using a 2 mm
allen wrench (Fig. 136).
Fig. 136 Shift Knob Retaining Screw
(3) If the vehicle is equipped with a manual trans-
mission remove the gearshift knob and shifter boot
using the following procedure.
• Push shifter boot down to expose clips on gear-
shift knob and roll pin on shifter handle (Fig. 137).
• Pry the clips on the shifter knob away from the
roll pin in the shifter handle using a flat blade pry
tool (Fig. 137).
• Remove the shifter knob from the shifter handle,
by pulling the shifter knob straight up (Fig. 138).
• Remove the shifter boot from the center console.
Shifter boot is removed by squeezing the bezel
together at the base of the shifter boot and pulling
upward on the boot (Fig. 139).
Fig. 137 Gearshift Knob
CLIPSBOOT GEARSHIFT MECHANISM ATTACHING SCREWS CENTER CONSOLE SHIFTER HANDLE SHIFTER KNOB SHIFTER BOOT
Fig. 138 Gearshift Knob Removal
Fig. 139 Boot Removal
(4) Remove the 2 screws attaching the front of the
center console to the gear selector or shifter (Fig.
140) or (Fig. 141).
Fig. 140 Center Console Front Attaching
Screws(Automatic)
PARK BRAKE HAND LEVER
SHIFTER HANDLE
BRAKES 5 - 55