Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 507

CONTINUITY SWITCH POSITION TERMINALS BETWEEN PIN 2 to 5 PIN 2 to 5 PIN 1 to 6 PIN 1 to 4 PIN 5 to 6 PIN 1 to 4 DOWN OFF UP
8S - 2 POWER WINDOWS
Master Window Switch
Passenger Window Switch
REMOVAL AND INSTALLATION
WINDOW MOTOR
WARNING: DO NOT HAVE ANY HANDS OR FIN-
GERS IN SECTOR GEAR AREA WHERE THEY CAN
Fig. 1
Fig. 2
MOTOR MOUNTING SCREWS
BE PINCHED BY SMALL MOVEMENTS OF REGULA-
TOR LINKAGE.
REMOVAL
(1) Move the window to the full-up position, if pos-
sible.
(2) Remove door trim panel and window regulator,
refer to Group 23 Body for removal procedures.
WARNING: FAILURE TO CLAMP THE SECTOR
GEAR TO THE MOUNTING PLATE WHEN REMOV-
ING THE MOTOR CAN RESULT IN INJURY.
(3) Disconnect wiring connector from motor.
(4) Secure the sector gear and mounting plate with
a C clamp or similar clamping tool. This will prevent
a sudden and forceful movement of the regulator
when the motor is removed.
(5) Remove three mounting screws that hold motor
gearbox to regulator (Fig. 3).
(6) Remove motor from regulator.
INSTALLATION
(1) Install new motor on regulator by positioning
motor gearbox so that it engages regulator sector
teeth.
(2) A slight rotational or rocking movement may
be necessary to bring three motor gearbox screw
holes into proper position.
(3) Install three gearbox screws and one tie down
bracket screw, if applicable. Tighten to 5.6 to 8 N·m
(50 to 70 in. lbs.) torque.
(4) Install regulator, using the switch, test opera-
tion of motor.
Fig. 3 Motor Removal
CLAMP REGULATOR TO SEC- TOR GEAR
JA