Automatic Shutdown Relay - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

IGNITION COIL BATTERY POSITIVE BATTERY GROUND AIR CLEANER PCM PDC TCM
JA
REMOVAL AND INSTALLATION (Continued)
IGNITION COIL—2.5L
The ignition coil is located in the distributor hous-
ing (Fig. 44).
Fig. 44 Ignition Coil
If ignition coil is defective, replace distributor
assembly. Refer to Distributor Service.

AUTOMATIC SHUTDOWN RELAY

The relay is located in the Power Distribution Cen-
ter (PDC) (Fig. 45). The PDC is located in the engine
compartment. For the location of the relay within the
PDC, refer to the PDC cover for location. Check elec-
trical terminals for corrosion and repair as necessary.
Fig. 45 Power Distribution Center (PDC)
DISTRIBUTOR HOUSING COIL TOWER CAMSHAFT POSITION SEN- REAR OF CYLINDER HEAD REAR OF CYLINDER HEAD SOR
CAMSHAFT POSITION SENSOR—SOHC
The camshaft position sensor is mounted to the
rear of the cylinder head (Fig. 46).
Fig. 46 Camshaft Position Sensor Location—SOHC
REMOVAL
(1) Disconnect the filtered air tube from the throt-
tle body and air cleaner housing. Remove filtered air
tube.
(2) Remove the air cleaner inlet tube.
(3) Disconnect electrical connectors from engine
coolant sensor and camshaft position sensor.
(4) Remove brake booster hose and electrical con-
nector from holders on end of cylinder head cover.
(5) Remove camshaft position sensor mounting
screws. Remove sensor.
(6) Loosen screw attaching target magnet to rear
of camshaft (Fig. 47).
Fig. 47 Target Magnet Removal/Installation
TARGET MAGNET MOUNTING BOLT
IGNITION SYSTEM 8D - 21