Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 86

STEERING KNUCKLE BEARING SHIELD OUTER C/V JOINT OUTER JOINT C/V
JA
REMOVAL AND INSTALLATION (Continued)
(5) Ensure that front of outer C/V joint which fits
against the face of the hub and bearing is free of
debris and moisture before installing outer C/V joint
into hub and bearing assembly (Fig. 15).
Fig. 15 Outer C/V Joint Inspection
(6) Slide driveshaft back into front hub (Fig. 16).
Then install steering knuckle onto the lower control
arm ball joint stud.
Fig. 16 Steering Knuckle Installation onOuter C/V
BEARING SHIELD STEERINGKNUCKLE. INSTALLING MOISTURE BEFORE ALL MUST BE FREE OF OUTER C/V JOINT THIS DEBRIS HUB/BEARING AREA
Joint
AND OF IN BRAKE CALIPER FLEX LOWER WHEEL SPEED SEN- CONTROL SOR CABLE ARM SPEED HOSE CASTLENUT
DIFFERENTIAL AND DRIVELINE
(7) Install the steering knuckle to ball joint stud
castle nut (Fig. 17). Tighten the castle nut to 95 N·m
(70 ft. lbs.).
Fig. 17 Lower Ball Joint to Steering
(8) If equipped with antilock brakes, install the
speed sensor cable on the steering knuckle and
securely tighten bolt (Fig. 18).
Fig. 18 Wheel Speed Sensor Cable RoutingBracket
SENSOR CABLE BRACKET ROUTING COTTER PIN ATTACHINGBOLT
KnuckleAttachment
BALL JOINT STUD STEERING STEERING KNUCKLE KNUCKLE
3 - 7