Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 138

VACUUM HOSE FROM INTAKE MANIFOLD
HEATER EGR
HOSES VALVE
JA
REMOVAL AND INSTALLATION (Continued)
(5) Remove the vacuum hoses (Fig. 95) from the
check valve located on the power brake vacuum
booster.
Fig. 95 Vacuum Hose Attachment To Check Valve
(6) Remove EGR valve transducer assembly and
vacuum hoses (Fig. 96) from the EGR valve. Valve
removal is necessary for required clearance to
remove power brake vacuum booster from vehi-
cle and not damage transducer during removal.
Fig. 96 EGR Valve Transducer Assembly
SPEED CONTROL VACUUM EGR VALVE TRANS- RESERVOIR HOSE DUCER EGR VALVE
VACUUM HOSE TO EGR
VALVE
BRAKE FLUID RES- CYLINDER MASTER ASSEMBLY ERVOIR MOUNTING NUTS (2)
(7) Remove the vehicle's wiring harness connector
from the master cylinder brake fluid level sensor
(Fig. 97).
Fig. 97 Master Cylinder Brake Fluid LevelSensor
(8) Remove the 2 nuts (Fig. 98) attaching the mas-
ter cylinder assembly to the power brake vacuum
booster.
Fig. 98 Master Cylinder Mounting
BRAKE TUBES MASTER CYLINDER FLUID LEVEL SENSOR MASTER CYLINDER VACUUM BRAKE
LEFT SHOCK
TOWER
BRAKES
BOOSTER
5 - 43