Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 913

LOWER ENGINE SUPPORT BRACKET UPPER TIMING BOLT COVER M12–1.75 WASHER BEARING COVER FASTENERS TIMING FROM AND FASTENERS FASTENERS 150 MM BOLT, TOOL 6792 BELT SPECIAL THRUST
9 - 76 2.4L ENGINE
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
Install crankshaft vibration damper using M12
1.75 x 150 mm bolt, washer, thrust bearing and nut
from Special Tool 6792. Install crankshaft vibration
damper bolt and tighten to 142 N·m (105 ft. lbs.)
(Fig. 50).
Fig. 50 Crankshaft Vibration Damper—Installation
TIMING BELT COVER
FRONT COVER
REMOVAL
(1) Remove crankshaft damper. Refer to crank-
shaft damper removal for procedure.
(2) Remove front timing belt cover fasteners (Fig.
51) and remove cover.
(3) Remove engine mount bracket (Fig. 51).
Fig. 51 Front Timing Belt Covers
REAR COVER TO CYLINDER REAR COVER TO ENGINE BLOCK FASTENERS HEAD FASTENERS BELT TENSIONER
INSTALLATION
(1) Install the engine mount bracket and front
timing belt cover (Fig. 51).
(2) Install crankshaft damper. Refer to crankshaft
damper installation for procedure.
REAR COVER
REMOVAL
(1) Remove Front Cover. Refer to Front Cover
Removal procedure outlined in this section.
(2) Remove Timing Belt. Refer to procedure out-
lined in this section.
(3) Remove idler pulleys (Fig. 52).
(4) Remove both camshaft sprockets.
(5) Remove rear timing belt fasteners and remove
cover from engine (Fig. 52).
Fig. 52 Rear Timing Belt Cover Fasteners
INSTALLATION
(1) Install rear timing belt cover and fasteners
(Fig. 52).
(2) Install idler (Fig. 52).
(3) Install camshaft sprockets.
(4) Install Timing Belt. Refer to procedure outlined
in this section.
JA